Add more workpiece support to the Adaptive Cutting System Project Table for full sheets of plywood or long boards with the Project Table Extension Brackets. These brackets mount in the aluminum perimeter frame of the Project Table and accept 2x4 boards that can then be supported at the other end by a Kreg Track Horse, Mobile Project Center, or another work support.
Made from thick steel, the Project Table Expansions Brackets are adjustable to position the 2x4s in two ways: flush with the surface of the Project table or 3/4" below the surface, which allows for adding a plywood surface to the enlarged table. Holes in the sides of the brackets allow driving the included screws into the 2x4s to hold them in place in the brackets.
Designed for use with the Adaptive Cutting System Project Table. Set includes two brackets, four 1-1/4" screws and owner's manual.
Request an invoice reprint for Warranty, Tax Filling or Insurance Claim purposes
*KMS Club Members Save up to 30% Off everyday. Online or in-store prices are pre-calculated with discounts and are shown online in red. In-store instant savings or prices are shown on each item label. No additional discounts required at checkout. Flyer or eFlyer savings may be greater!
*KMS Club Members Save up to 30% Off everyday. Online or in-store prices are pre-calculated with discounts and are shown online in red. In-store instant savings or prices are shown on each item label. No additional discounts required at checkout. Flyer or eFlyer savings may be greater!