New Line AODKIT-2 3/4" O.D. Home Garage/Shop Compressed Air System Complete Master Kit

This Air-On-Demand (AOD) kit is designed for a home garage or small shop setup, typically a single user about 50ft from the compressor. This kit can be run along ceilings, walls, or benches and provides parts needed for 2 outlets. Prior to starting the installation, determine a suitable layout. For draining of condensation buildup in lines, vertical drops should have a drain valve (included) threaded into the bottom of the aluminum manifold, and horizontal runs should have the valve threaded into the last manifold. Condensation in air systems should be drained at regular intervals.

After the layout is determined, thread all tube fittings to aluminum manifolds using PTFE Thread Tape. Mount manifolds directly to bench, walls or ceilings using suitable hardware, locating a stud or joist if mounting through wallboard. Thread MNPT x Tube fitting into the compressor or air source. Use support clamps (included) to secure tubing for safe and tidy routing.

Includes:

• 50 ft - 3/4" Outside Diameter Tubing
  
• 2 - Brass 3/4" O.D. Push-In Tube 90° Elbows
  
• 1 - Brass 3/4" O.D. Push-In Tee
  
• 2 - 1/2" Brass Hex Head Plug
  
• 4 - 1/2" MNPT Close Nipples
  
• 4 - 1/2" Brass MNPT x 3/4" O.D. Push-In Tube
  
• 2 - 1/2" Brass Extruded 45° Street Elbows
  
• 2 - 1/2" Brass Full Port Valves
  
• 2 - Round Aluminum Manifolds
  
• 1 - Roll PTFE Tape
  
• 1 - Hose Cutter For Up To 2" Hose
  
• 10 - Cushioned Tube Supports