This is a great starter mill/drill that won’t take up a lot of space in your workshop. This tool has been used for cylinder head resurfacing of small engines, but it has also seen use in dental clinics. Whatever the use, KMS has all the accessories needed for this beefed up mill/drill press.
- Spindle is equipped with four heavy-duty tapered roller bearings
- Table control hand wheels have large micrometer dials graduated in .001”
- Head swivels 360° and is easily raised and lowered
- Comes with 3” face cutter, 1/2” chuck with key and 3 1/2" angle vise
- Drilling capacity: 1 1/4"
- Max. distance spindle nose to table: 18 7/8"
- Swing: 16 1/2"
- Spindle taper: R8
- Spindle Stroke: 5"
- Diameter of Column: 4-3/4"
- Speeds: 12 (150-2500) RPM
- Face mill capacity: 3"
- End mill capacity: 3/4"
- Max. table travel: 17 1/2"
- Working area of table: 8-1/4" x 28-3/4"
- Size of T-Slot on table: 5/8"
- Motor: 22 amp. @ 110V, 11 amp. @ 220V
- Voltage: 110/220V, 1 phase, 60 Hz
- Pre-wired at 110V
- Dimensions (LxWxH): 43" x 39" x 42"
- Common accessories for this machine:
- MAG-CCS15PCR8S Collet Check Set, to hold end mills and drill bits.
- Collets hold from 1/8 inch to 1 inch shank, by 1/16ths inch increments.
- MAG-R8EMH38 single end mill holder, for 3/8" shank end mills.
- SOU-SB1280 drawbolt collet set, holds end mills with 1/8" to 7/8" shank
- Upgrade machinist vises from 4" to 6" sizes available. (See MAG-PL00 & MAG-PL160)
- Upgrade drill press vises from 4" to 6" sizes available. (See SOU-SB1215 & SOU-SB1216)
- See Milling Accessories for other accessories like End Mills, Rotary Tables, Machinist Squares and Levels
