This is a higher viscosity CA for loose fitting joints in which the adhesive must bridge gaps. Normally, the thicker CA is applied to one surface and then the parts are held tightly together for about 5 to 15 seconds. For large surface areas, including those with close fitting joints such as laminations, INSTA-CURE+ should also be used. To prevent premature curing, don’t spread the glue into a thin film. Lay down a serpentine bead with about 1" separations on one surface, then assemble the parts, letting the pressure spread the CA out.
Higher Viscosity
Dries in 5-15 seconds
Works best on balsa & soft woods
Save up to 30%* Off everyday, online or in-store
It's Free to Join, Save up to 30 %
Exclusive 5-Star Advantage Plan
Group Rewards
Exclusive promotional emails & discounts
Receive our monthly flyer
Easily access your online order history
Save multiple shipping addresses
Request an invoice reprint for Warranty, Tax Filling or Insurance Claim purposes
*KMS Club Members Save up to 30% Off everyday. Online or in-store prices are pre-calculated with discounts and are shown online in red. In-store instant savings or prices are shown on each item label. No additional discounts required at checkout. Flyer or eFlyer savings may be greater!
*KMS Club Members Save up to 30% Off everyday. Online or in-store prices are pre-calculated with discounts and are shown online in red. In-store instant savings or prices are shown on each item label. No additional discounts required at checkout. Flyer or eFlyer savings may be greater!